top of page

TOOLING FOR

HARDINGE-TYPE CHUCKERS

The following collet chucks are designed to increase machining efficiency on Hardinge-type chuckers.

 

 

 

 

Available for both ER and DA collets

  • 5/8" shank diameter for maximum efficiency on your Hardinge Chucker

  • Small diameter lock nut for machining hard-to-reach surfaces

  • Shorter shank length than Extensions, ideal for use on chuckers 

  • Shorter length lock nut on "STUBBY" reduces machine set-up time

  • Available for both ER and Double Angle collets

  • All lock nuts (including ER) can be tightened with a standard open-end wrench (no special wrench needed)

 

 

 5/8" SHANK "STUBBY" COLLET CHUCKS

DA300 - DA200 - ER11 - ER16 - ER20

AVAILABLE ACCESSORIES

All back up screws have 1/8" hex. socket. 

*DO NOT OVER-TIGHTEN LOCK NUT, ALWAYS USE BACKUP SCREW

bottom of page